What To Do If Your Water Heater All Of A Sudden Stops Working

What To Do If Your Water Heater All Of A Sudden Stops Working

Blog Article


Just about every person has got their private perception with regards to No Hot Water — Water Heater Repair.

Hot Water Heater Repair
Lots of modern houses take advantage of an electrical water heater for their heater, due to its benefit and also ease of use. Nevertheless, similar to any other electrical appliances, issues might occur with its use, all of a sudden. It can be really aggravating to awaken to a cold shower rather than a warm one or having your bathroom with water that isn't hot sufficient or perhaps also hot. Whatever the situation might be, hot water heater problems can be rather aggravating. The good news is, we've made a list of possible options to your hot water heater issues. There are a number of aspects that can create a lot of these issues, maybe a problem with the power supply, the electric burner, or the thermostat. Prior to doing anything, guarantee you turn off the main power supply for security. Whatever the issue is, getting it taken care of must not posture too much of an issue if you follow these steps:

Inspect Your Power Supply:

As fundamental as this might appear, it is really essential. Without adequate power, your water heater will not function. So the first thing to do when your water all of a sudden stops working is to verify that it isn't a power issue. Inspect if the fuse is blown out or the circuit breaker tripped. If the circuit breaker is the problem, just turn it off and on once again. Replace any type of damaged or worn-out fuse. Evaluate the home appliance with power after these modifications to see if it's now working.

Check the Heating Element in the Water Heater:

If it's not a power problem, then try checking out your burner if it is still functioning. Check each of your burner to ensure the issue isn't with any of them. If any of them is defective, change that component and afterwards examine whether the warm water is back on.

Examine Your Thermostat:

If your hot water heater still isn't functioning or the water appearing isn't warm sufficient, you might require to inspect the temperature settings on your upper thermostat. Guarantee the circuit breaker is switched off before doing anything. Open the access panel and press the red button for temperature level reset over the thermostat. This must assist heat up the water. Turn the circuit breaker back on and check if the problem has actually been settled.

Call A Professional:

If after changing all damaged components as well as resetting your temperature, the water heater still isn't working, you may require to speak to a professional plumber for an expert viewpoint. The problem with your heater could be that the cold and hot taps have been switched or it might be undersized for the quantity of hot water needed in your house. Whatever the instance might be, a professional plumber would aid resolve the problem.


Hot water heater issues are not always major. Most of them are because of minor concerns like a blown fuse or damaged heating element. Replacing the damaged parts should suffice. Nevertheless, if you are still unable to address the issue, give a call to your closest plumber ahead to get it taken care of.

Common Reasons Why Your Hot Water Heater Isn’t Working

Water Gets Too Hot

Ouch! You wanted a hot shower, not boiling! If you have a newer model electric water heater, your water heater works with a thermostat (actually, two thermostats). If this thermostat has been jostled — or purposely reset — by someone in your home, the water flow will be much hotter than you expected.

FIX: Adjust the thermostat to a more moderate setting for producing hot water. Forty-nine degrees Celsius is recommended to prevent scalding.

Water Doesn’t Get Hot

This is the opposite of the previous problem, but it’s almost as bad. Your flow of hot water is merely lukewarm or even incoming cold water. Once again, an incorrect thermostat setting, or a faulty thermocouple in a gas water heater, could be to blame. Another explanation might be that there’s no power to the water heater (in the case of an electric heater) or the pilot light has gone out (if you have a gas unit).

FIX: Adjust your thermostat as necessary. If that doesn’t do the trick, check the power supply. Another possibility is the replacement of a damaged thermocouple in gas water heaters.

Leaking Water Heater

A leaking water heater (a sign may be low hot water pressure, or not enough hot water to shower) might be a reason to push the panic button… but first, take a few minutes to check where the leakage is coming from. Leaks near the top of the heater tend to indicate a problem with a valve, which won’t need a major repair. However, a leak from the water heater base is more serious.

FIX: You may need a qualified plumber to replace your drain valve or TPR (temperature pressure relief) valve. When your water heater is leaking from below, your plumber might be able to fix it if you call them soon enough. Otherwise, you will need to have a new water heater installed.

Noisy Water Heater

Sometimes your water heater might make some peculiar noises, loud enough to compete with your singing in the shower. Are these a cause for alarm? It depends on exactly what kind of sounds you are hearing. Sizzles and rumbles are both red flags, indicating a heavy sediment buildup in your hot water tank that might cause a breakdown in the near future. In addition, banging is a sign of a water hammer, which can lead to serious damage to your pipes.

FIX: To stop sizzling or rumbling, turn off the tank and have it flushed by a reliable plumbing company ASAP. Ask your plumber to install a water hammer arrestor to quiet down the banging and save the pipes.

Pilot Light Keeps Going Out

Many pilot lights go out once in a while, but when your water heater pilot light keeps going out continually, it’s a problem. And the chances are good that that problem stems from either a shortage of combustible air or a malfunctioning thermocouple.

FIX: Increase the air supply around your water heater by cleaning dust and lint off the appliance and clearing any clutter from the area around it. A bad thermocouple will require expert plumbing repair and is more than basic gas water heater troubleshooting.

Water Smells Bad

The water from your residential plumbing pipes should smell neutral. If it has a strong unpleasant odour, something’s wrong. To check whether your water heater is at fault, turn on a hot water faucet and let it run for a few minutes. And, yes, use your nose to determine exactly what you are smelling.

FIX: For a garlicky odour, relight the pilot light on your water tank. When you detect the scent of garbage, you’ll need a professional plumber to flush the hot water tank and possibly replace the anode rod. A strong smell of rotten eggs could signal a hazardous gas leak; turn off the gas supply if possible, get everyone out of your house, and make an emergency call to the gas company.

Water Looks Brown Or Rusted

The first thing to do is ask yourself, “Is the brown, rusty-looking water coming only from my hot water taps?” If the answer is yes, then most likely, either the anode rod or the water heater interior is starting to rust, especially if your hot water heater is nearing the end of its life expectancy. (A “no” answer means the issue does not originate from the hot water heater but rather from the water supply.)

FIX: Contact a plumber to inspect the water heater. If you catch the problem quickly enough, it might be fixable. Otherwise, you’ll need a water heater replacement. Consider installation of an efficient new tankless water heater.


I am very involved in No Hot Water — Water Heater Repair and I hope you enjoyed reading the entire blog posting. Please set aside a second to share this blog posting if you enjoyed it. Thank you for your time. Don't forget to stop by our site back soon.

Visit My Site

Report this page